Replacement Flag line 2 for the Controller 4.
- 1x Replacement Flag line (bungee line)
REMOVE OLD FLAG LINE
1 - Remove ring from Flag line
2 - Pull Flag back through release, bar, and cleat ring
3 - Slide stopper ball up the flying line then remove safety Flag line
INSTALL NEW FLAG LINE
1 - Slide stopper ball up the flying line.
2 - Thread new safety Flag line through flying line loop
3 - IMPORTANT Reef knot must be sitting properly
4 - IMPORTANT Reef knot is tidy and pulled very tight
5 - Pull stopper ball tightly into place over the reef knot
6 - Thread Flag line through cleat ring, bar center and then quick release
7 - Thread ring onto safety Flag line
8 - When complete check reef knot pulls through quick release
The system relies on the high pressure on the reef knot in the stopper ball to keep knot the right shape and size to freely pull through the quick release